ASTM C1305 / C1305M - 16

    Standard Test Method for Crack Bridging Ability of Liquid-Applied Waterproofing Membrane

    Active Standard ASTM C1305 / C1305M | Developed by Subcommittee: D08.22

    Book of Standards Volume: 04.04


      Format Pages Price  
    PDF 3 $40.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $40.00   ADD TO CART
    Standard + Redline PDF Bundle 6 $48.00   ADD TO CART


    Significance and Use

    5.1 This test method is used to indicate a waterproofing membrane's ability to maintain its integrity while bridging a preexisting crack in the substrate at low ambient temperatures, when the membrane is least likely to be flexible.

    1. Scope

    1.1 This test method covers a laboratory procedure for determining the ability of a waterproofing membrane to bridge a crack in the substrate.

    1.2 There are no ISO standards similar or equivalent to this ASTM standard.

    1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    ICS Code

    ICS Number Code 91.100.50 (Binders. Sealing materials)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C1305_C1305M-16

    Citation Format

    ASTM C1305 / C1305M-16, Standard Test Method for Crack Bridging Ability of Liquid-Applied Waterproofing Membrane, ASTM International, West Conshohocken, PA, 2016, www.astm.org

    Back to Top