| Format | Pages | Price |   |
![]() |
5 | $50.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 5 | $50.00 | ![]() |
![]() |
Standard + Redline PDF Bundle ![]() |
10 | $60.00 | ![]() |
Historical Version(s) - view previous versions of standard
More B01.05 Standards Related Products Standard References
1. Scope
1.1 This specification covers round, extra-high-strength, and ultra-high-strength, Class A coated zinc–5 % aluminum-mischmetal (Zn–5Al–MM) alloy-coated, steel core wire for use in Overhead Electrical Conductors.
1.2 This specification covers wire of diameter from 0.0500 to 0.1900 in. inclusive or 1.27 to 4.82 mm inclusive.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A90/A90M Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
B193 Test Method for Resistivity of Electrical Conductor Materials
B750 Specification for GALFAN
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E1277 Test Method for Analysis of Zinc-5 % Aluminum-Mischmetal Alloys by ICP Emission Spectrometry
ICS Code
ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)
UNSPSC Code
UNSPSC Code 26121500(Electrical wire)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/B0958_B0958M-19
Citation Format
ASTM B958 / B958M-19, Standard Specification for Extra-High-Strength and Ultra-High-Strength Class A Zinc–5% Aluminum-Mischmetal Alloy-Coated Steel Core Wire for Use in Overhead Electrical Conductors, ASTM International, West Conshohocken, PA, 2019, www.astm.org
Back to Top