| ||Format||Pages||Price|| |
|3||$42.00||  ADD TO CART|
|Hardcopy (shipping and handling)||3||$42.00||  ADD TO CART|
|Standard + Redline PDF Bundle||6||$50.00||  ADD TO CART|
This specification covers the standard for magnesium alloys in ingot and stick forms proposed for used in remelting. Magnesium 9980A alloys are available in ingot and stick form. Magnesium 9980B, 9990A, 9995A, and 9998A, on the other hand, are generally available in ingot form only. The specimens shall be produced with no slag and shall have a clean surface free from dirt, slag, or other foreign contaminants. Alloys shall adhere to specified chemical composition requirements. Any suitable chemical analysis method can be used unless otherwise prescribed.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1.1 This specification covers magnesium in the form of ingot and stick for remelting: 9980A is available in ingot and stick form, and 9980B, 9990A, 9995A, and 9998A are generally available only in ingot form.
1.2 The values stated in SI units are to be regarded as a separate standard. The values stated in each system are not exact equivalents, therefore each system must be used independently of the other.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B951 Practice for Codification of Unalloyed Magnesium and Magnesium-Alloys, Cast and Wrought
B953 Practice for Sampling Magnesium and Magnesium Alloys for Spectrochemical Analysis
B954 Test Method for Analysis of Magnesium and Magnesium Alloys by Atomic Emission Spectrometry
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E88 Practice for Sampling Nonferrous Metals and Alloys in Cast Form for Determination of Chemical Composition
ICS Number Code 77.150.20 (Magnesium products)
UNSPSC Code 30261900(Magnesium ingots strips billets and coil)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B92 / B92M-17, Standard Specification for Unalloyed Magnesium Ingot and Stick For Remelting, ASTM International, West Conshohocken, PA, 2017, www.astm.orgBack to Top