You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM B755-00(2016)

    Standard Specification for Nickel-Chromium-Molybdenum-Tungsten Alloys (UNS N06110) Plate, Sheet, and Strip (Withdrawn 2021)

    Withdrawn Standard: ASTM B755-00(2016) | Developed by Subcommittee: B02.07


      Format Pages Price  
    PDF 7 $62.00   ADD TO CART


    Withdrawn Rationale:

    This specification covers rolled nickel-chromium-molybdenum-tungsten alloys (UNS N06110) plate, sheet, and strip.

    Formerly under the jurisdiction of Committee B02 on Nonferrous Metals and Alloys, this specification was withdrawn in April 2021. This standard is being withdrawn without replacement because the material, UNS N06110, is no longer being produced.

    1. Scope

    1.1 This specification covers rolled nickel-chromium-molybdenum-tungsten alloys (UNS N06110)2 plate, sheet, and strip.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B446 Specification for Nickel-Chromium-Molybdenum-Columbium Alloy (UNS N06625), Nickel-Chromium-Molybdenum-Silicon Alloy (UNS N06219), and Nickel-Chromium-Molybdenum-Tungsten Alloy (UNS N06650) Rod and Bar

    B756 Specification for Nickel-Chromium-Molybdenum-Tungsten Alloy(UNS N06110) Rod and Bar

    B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys

    E8 Test Methods for Tension Testing of Metallic Materials

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)

    E1473 Test Methods for Chemical Analysis of Nickel, Cobalt and High-Temperature Alloys


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0755-00R16

    Citation Format

    ASTM B755-00(2016), Standard Specification for Nickel-Chromium-Molybdenum-Tungsten Alloys (UNS N06110) Plate, Sheet, and Strip (Withdrawn 2021), ASTM International, West Conshohocken, PA, 2016, www.astm.org

    Back to Top