You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM B722-06(2016)

    Standard Specification for Nickel-Chromium-Molybdenum-Cobalt-Tungsten-Iron-Silicon Alloy (UNS N06333) Seamless Pipe and Tube (Withdrawn 2021)

    Withdrawn Standard: ASTM B722-06(2016) | Developed by Subcommittee: B02.07


      Format Pages Price  
    PDF 3 $54.00   ADD TO CART


    Withdrawn Rationale:

    This specification covers alloy N06333 in the form of hot-finished and cold-finished seamless pipe and tube intended for heat-resisting applications and general corrosive service.

    Formerly under the jurisdiction of Committee B02 on Nonferrous Metals and Alloys, this specification was withdrawn in April 2021. This standard is being withdrawn without replacement because N06333 is no longer being produced in seamless pipe or tube.

    1. Scope

    1.1 This specification covers alloy N06333 in the form of hot-finished and cold-finished seamless pipe and tube intended for heat-resisting applications and general corrosive service. The general requirements for pipe and tube are covered in Specification B829.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B829 Specification for General Requirements for Nickel and Nickel Alloys Seamless Pipe and Tube


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0722-06R16

    Citation Format

    ASTM B722-06(2016), Standard Specification for Nickel-Chromium-Molybdenum-Cobalt-Tungsten-Iron-Silicon Alloy (UNS N06333) Seamless Pipe and Tube (Withdrawn 2021), ASTM International, West Conshohocken, PA, 2016, www.astm.org

    Back to Top