ASTM B67 - 14
Standard Specification for Car and Tender Journal Bearings, Lined
| Format | Pages | Price | ||
 |
3 | $40.00 |  ADD TO CART |
|
 |
Hardcopy (shipping and handling) | 3 | $40.00 | ADD TO CART |
|
Standard + Redline PDF Bundle  |
6 | $48.00 | ADD TO CART |
Historical Version(s) - view previous versions of standard
Abstract
This specification covers the establishment of requirements for lined journal bearings for use on locomotive tenders, passenger cars, and freight equipment cars. Before lining, the brass backs shall be bored and thoroughly tinned in accordance with the best standard practice. After lining, the ends of the bearings shall be made smooth by scraping, filing, or machining. The backing metal shall conform to the requirements specified for named elements for copper alloy UNS No. C94100. The lining metal shall conform to the chemical composition requirements specified for named elements. The finished bearing representing a lot for acceptance shall be broken, either longitudinally or transversely, or both, in order to ascertain the uniformity of the grain of the metal. The chemical analysis of the lining shall be made accordingly.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers the establishment of requirements for lined journal bearings for use on locomotive tenders, passenger cars, and freight equipment cars. The alloy specified is UNS No. C94100.2
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B824 Specification for General Requirements for Copper Alloy Castings
E57 Methods for Chemical Analysis of White Metal Bearing Alloys
E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
ICS Code
ICS Number Code 43.040.50 (Transmissions, suspensions)
UNSPSC Code
UNSPSC Code 31171500(Bearings)
Referencing This Standard
| Link Here | |||
| Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/B0067
Citation Format
ASTM B67-14, Standard Specification for Car and Tender Journal Bearings, Lined, ASTM International, West Conshohocken, PA, 2014, www.astm.org
Back to Top