| Format | Pages | Price |   |
![]() |
5 | $52.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 5 | $52.00 | ![]() |
Historical Version(s) - view previous versions of standard
More B10.02 Standards Related Products Standard References
Abstract
This specification covers seamless and welded zirconium and zirconium alloy pipe. The pipe is furnished in three grades as follows; grade R60702- unalloyed zirconium, grade R60704- zirconium-tin alloy, and grade R60705- zirconium-niobium alloy. Seamless pipe shall be made from any seamless method that will yield a product meeting the requirements prescribed. Pipe containing welded seams or other joints made by welding shall comply with the given provisions. The pipe shall be furnished in the annealed or stress-relieved condition. The material shall conform to the requirements as to chemical composition prescribed. The material, as represented by the test specimens, shall conform to the tensile properties prescribed.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification2 covers three grades of seamless and welded zirconium pipe.
1.2 Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values.
1.3 The following precautionary caveat pertains only to the test methods portions of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B614 Practice for Descaling and Cleaning Zirconium and Zirconium Alloy Surfaces
E8/E8M Test Methods for Tension Testing of Metallic Materials
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E2626 Guide for Spectrometric Analysis of Reactive and Refractory Metals
ASME Standard
ASME Boiler and Pressure Vessel Code, Section IXICS Code
ICS Number Code 23.040.15 (Non-ferrous metal pipes)
UNSPSC Code
UNSPSC Code 40171516(Commercial non ferrous pipe)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/B0658_B0658M-11R20
Citation Format
ASTM B658 / B658M-11(2020), Standard Specification for Seamless and Welded Zirconium and Zirconium Alloy Pipe, ASTM International, West Conshohocken, PA, 2020, www.astm.org
Back to Top