ASTM B536 - 19

    Standard Specification for Nickel-Iron-Chromium-Silicon Alloys Plate, Sheet, and Strip

    Active Standard ASTM B536 | Developed by Subcommittee: B02.07

    Book of Standards Volume: 02.04


      Format Pages Price  
    PDF 3 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $46.00   ADD TO CART
    Standard + Redline PDF Bundle 6 $54.00   ADD TO CART



    Abstract

    This specification covers nickel-iron-chromium-silicon alloys (UNS N08330 and N08332) plate, sheet, and strip intended for heat resisting applications and general corrosive service. The alloy UNS N08830 and UNS N08332 shall be annealed at a certain temperature. The material shall conform to the chemical composition requirements prescribed by the reference material. The tensile properties of the material at room temperature shall conform to the reference material. The annealed alloy UNS N08332 shall conform to an average grain size, there are no grain size requirements for UNS N08330.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification covers nickel-iron-chromium silicon alloys (UNS N08330 and UNS N08332)2 plate, sheet, and strip intended for heat resisting applications and general corrosive service.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B899 Terminology Relating to Non-ferrous Metals and Alloys

    B906 Specification for General Requirements for Flat-Rolled Nickel and Nickel Alloys Plate, Sheet, and Strip


    ICS Code

    ICS Number Code 77.150.40 (Nickel and chromium products)

    UNSPSC Code

    UNSPSC Code 30266600(Nickel sheets and ingots)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0536-19

    Citation Format

    ASTM B536-19, Standard Specification for Nickel-Iron-Chromium-Silicon Alloys Plate, Sheet, and Strip, ASTM International, West Conshohocken, PA, 2019, www.astm.org

    Back to Top