You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM B531-90(1998)e1

    Standard Specification for Aluminum-Alloy 5005 Drawing Stock for Electrical Purposes (Withdrawn 2003)

    Withdrawn Standard: ASTM B531-90(1998)e1 | Developed by Subcommittee: B01.07


      Format Pages Price  
    PDF 3 $48.00   ADD TO CART


    1. Scope

    1.1 This specification covers aluminum-alloy 5005 Drawing stock, 0.375 in. (9.52 mm) in diameter, in the tempers shown in Table 1, for drawing into wire for electrical conductors (Explanatory Notes 1 and 2).

    1.2 The SI values for density and resistivity are regarded as the standard. For all other properties the inch-pound values are to be regarded as standard and the SI units may be approximate.

    Note 1-The alloy and temper designations conform to ANSI H35.1. Aluminum-alloy 5005 corresponds to unified numbering system alloy A95005 in accordance with Practice E527.



    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0531-90R98E01

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM B531-90(1998)e1, Standard Specification for Aluminum-Alloy 5005 Drawing Stock for Electrical Purposes (Withdrawn 2003), ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top