| Format | Pages | Price |   |
![]() |
3 | $46.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 3 | $46.00 | ![]() |
Historical Version(s) - view previous versions of standard
Work Item(s) - proposed revisions of this standard
More B02.07 Standards Related Products Standard References
Abstract
This specification covers nickel-molybdenumchromium-iron alloys (UNS N10003 and UNSN10242) plate, sheet, and strip for use in general corrosive service. Alloys in the form of sheet, strips, and plates may be hot or cold rolled, annealed, and descaled. Physical properties like grain size, weight, thickness, width, length, straightness, squareness, flatness, and edges of the specimens shall be determined. Plate and sheet mechanical properties like tensile strength, yield strength, and elongation shall be measured.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification2 covers nickel-molybdenum-chromium-iron alloys (UNS N10003 and UNS N10242)3 plate, sheet, and strip for use in general corrosive service.
1.2 The following products are covered under this specification:
1.2.1 Sheet and Strip—Hot or cold rolled, annealed, and descaled unless annealing is performed in an atmosphere yielding a bright finish.
1.2.2 Plate—Hot rolled, annealed, and descaled.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B906 Specification for General Requirements for Flat-Rolled Nickel and Nickel Alloys Plate, Sheet, and Strip
ICS Code
ICS Number Code 77.150.40 (Nickel and chromium products)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/B0434-06R16
Citation Format
ASTM B434-06(2016), Standard Specification for Nickel-Molybdenum-Chromium-Iron Alloys (UNS N10003, UNS N10242) Plate, Sheet, and Strip, ASTM International, West Conshohocken, PA, 2016, www.astm.org
Back to Top