ASTM B319 - 91(2014)

    Standard Guide for Preparation of Lead and Lead Alloys for Electroplating

    Active Standard ASTM B319 | Developed by Subcommittee: B08.02

    Book of Standards Volume: 02.05

      Format Pages Price  
    PDF 4 $42.00   ADD TO CART
    Hardcopy (shipping and handling) 4 $42.00   ADD TO CART

    Significance and Use

    3.1 The preparation of lead and lead-alloy surfaces for electroplating is often critical to the successful performance of electrodeposited and autocatalytic metallic coatings.

    3.2 This standard outlines the process operation procedures and processing solutions required, that lead to satisfactory electrodeposited metallic coatings (including undercoating) on surfaces of lead and lead-alloys.

    1. Scope

    1.1 This guide provides methods for preparing lead or lead alloy products for the application of electroplated or autocatalytic coatings.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B281 Practice for Preparation of Copper and Copper-Base Alloys for Electroplating and Conversion Coatings

    ICS Code

    ICS Number Code 25.220.40 (Metallic coatings)

    UNSPSC Code

    UNSPSC Code 11101714(Lead)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0319-91R14

    Citation Format

    ASTM B319-91(2014), Standard Guide for Preparation of Lead and Lead Alloys for Electroplating, ASTM International, West Conshohocken, PA, 2014,

    Back to Top