ASTM B282 - 83a(1995)e1 Standard Specification for Sintered Brass Structural Parts (Withdrawn 2000)

You are being redirected because this document is part of your ASTM Compass® subscription.

This document is part of your ASTM Compass® subscription.

ASTM B282-83a(1995)e1

Standard Specification for Sintered Brass Structural Parts (Withdrawn 2000)

Withdrawn Standard: ASTM B282-83a(1995)e1 | Developed by Subcommittee: B09.05

There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
(Click here to view IHS phone and email contact details).

Reprints and Permissions

Permissions to reprint documents can be acquired through
Copyright Clearance Center Visit Copyright Clearance Center

Reprints and Permissions

Permissions to reprint documents can be acquired through
Copyright Clearance Center

Visit Copyright Clearance Center

Reprints and Permissions

Permissions to reprint documents can be acquired through
Copyright Clearance Center

Visit Copyright Clearance Center

ASTM License Agreement

1. Scope

1.1 This specification covers sintered metal powder structural parts made of one copper-zinc-lead powder composition of two types depending on density.

1.2 The values stated in inch-pound units are the standard. The SI values in parentheses are for information only and may be approximate.

Note 1-Definitions of powder metallurgy terms can be found in Definitions B243 and additional useful information is available in the Related Material section of Vol 02.05 of the Annual Book of ASTM Standards.

Referencing This Standard

Link Here

Link to Active (This link will always route to the current Active version of the standard.)

DOI: 10.1520/B0282-83AR95E01

Citation Format

ASTM B282-83a(1995)e1, Standard Specification for Sintered Brass Structural Parts (Withdrawn 2000), ASTM International, West Conshohocken, PA, 1995, www.astm.org