ASTM B164 - 03(2019)

    Standard Specification for Nickel-Copper Alloy Rod, Bar, and Wire

    Active Standard ASTM B164 | Developed by Subcommittee: B02.07

    Book of Standards Volume: 02.04


      Format Pages Price  
    PDF 9 $48.00   ADD TO CART
    Hardcopy (shipping and handling) 9 $48.00   ADD TO CART



    Abstract

    This specification covers nickel-copper alloys UNS N04400 and N04405 in the form of hot-worked and cold-worked rod, bar, and wire. The material shall conform to the chemical composition limits specified by the reference material. The materials for rod, bar, or wire shall conform to the mechanical properties specified by the reference material. One test per lot shall be performed for chemical analysis, tension test, hardness test, and wrapping test.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification2 covers nickel-copper alloys UNS N04400 and N044053 in the form of hot-worked and cold-worked rod and bar in the conditions shown in Table 1 and cold-worked wire in the conditions shown in Table 2.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B127 Specification for Nickel-Copper Alloy (UNS N04400) Plate, Sheet, and Strip

    B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys

    E8/E8M Test Methods for Tension Testing of Metallic Materials

    E18 Test Methods for Rockwell Hardness of Metallic Materials

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E76 Test Methods for Chemical Analysis of Nickel-Copper Alloys

    E140 Hardness Conversion Tables for Metals Relationship Among Brinell Hardness, Vickers Hardness, Rockwell Hardness, Superficial Hardness, Knoop Hardness, Scleroscope Hardness, and Leeb Hardness

    E1473 Test Methods for Chemical Analysis of Nickel, Cobalt and High-Temperature Alloys


    ICS Code

    ICS Number Code 77.150.40 (Nickel and chromium products)

    UNSPSC Code

    UNSPSC Code 30266002(Non ferrous alloy bar); 30102402(Non ferrous alloy rods)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0164-03R19

    Citation Format

    ASTM B164-03(2019), Standard Specification for Nickel-Copper Alloy Rod, Bar, and Wire, ASTM International, West Conshohocken, PA, 2019, www.astm.org

    Back to Top