If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM B134 / B134M - 15(2021)

    Standard Specification for Brass Wire

    Active Standard ASTM B134 / B134M | Developed by Subcommittee: B05.02

    Book of Standards Volume: 02.01


      Format Pages Price  
    PDF 7 $52.00   ADD TO CART
    Hardcopy (shipping and handling) 7 $52.00   ADD TO CART



    Abstract

    This specification establishes the requirements for round, hexagonal, octagonal, rectangular and square brass wire of UNS Alloy Nos. C21000, C22000, C22600, C23000, C23400, C24000, C26000, C27000, and C27400. The chemical composition, temper, annealed wire grain size, Rockwell hardness, and tensile strength requirements are detailed.

    This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

    1. Scope

    1.1 This specification establishes requirements for round, hexagonal, octagonal, rectangular and square brass wire of UNS Alloy Nos. C21000, C22000, C22600, C23000, C23400, C24000, C26000, C27000, and C27400.

    1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

    1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B250/B250M Specification for General Requirements for Wrought Copper Alloy Wire

    B601 Classification for Temper Designations for Copper and Copper AlloysWrought and Cast

    B846 Terminology for Copper and Copper Alloys

    E8/E8M Test Methods for Tension Testing of Metallic Materials

    E112 Test Methods for Determining Average Grain Size

    E478 Test Methods for Chemical Analysis of Copper Alloys


    ICS Code

    ICS Number Code 77.150.30 (Copper products)

    UNSPSC Code

    UNSPSC Code 26121547(Brass wire)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0134_B0134M-15R21

    Citation Format

    ASTM B134 / B134M-15(2021), Standard Specification for Brass Wire, ASTM International, West Conshohocken, PA, 2021, www.astm.org

    Back to Top