| ||Format||Pages||Price|| |
|5||$54.00||  ADD TO CART|
|Hardcopy (shipping and handling)||5||$54.00||  ADD TO CART|
Significance and Use
3.1 This test method covers the determination of the change of resistance with temperature for precision resistors and shunts made from sheet materials.
3.2 Materials normally used in the temperature range from 0 to 80°C may be tested using this test method.
1.1 This test method covers the determination of the change of resistance with temperature of sheet materials used for shunts and precision resistors for electrical apparatus. It is applicable to materials normally used in the temperature range of from 0 to 80°C.
1.2 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B84 Test Method for Temperature-Resistance Constants of Alloy Wires for Precision Resistors
ICS Number Code 77.140.50 (Flat steel products and semi-products)
UNSPSC Code 32121600(Resistors)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B114-07(2018), Standard Test Method for Temperature-Resistance Constants of Sheet Materials for Shunts and Precision Resistors, ASTM International, West Conshohocken, PA, 2018, www.astm.orgBack to Top