ASTM B1007 - 17

    Standard Specification for Welded Precipitation Hardenable or Cold Worked, Nickel Alloy Tube

    Active Standard ASTM B1007 | Developed by Subcommittee: B02.07

    Book of Standards Volume: 02.04


      Format Pages Price  
    PDF 5 $52.00   ADD TO CART
    Hardcopy (shipping and handling) 5 $52.00   ADD TO CART



    1. Scope

    1.1 This specification covers nominal and minimum wall-thickness welded tubes and welded and cold worked tubes made from the nickel alloys listed in Table 1. Anticipated uses cover applications where strength and strength at elevated temperatures are desired attributes. Some examples are hydraulic control lines, boilers, heat exchangers, and solar absorbers.

    (A) Columbium or Niobium (Nb) are references to the same element.
    (B) Remainder: The element may be determined arithmetically by difference.
    (C) Minimum: The element may be determined arithmetically by difference.

    1.2 Tube shall be supplied in one of the following conditions; cold worked, cold worked and precipitation hardened, solution annealed plus precipitation hardened, or solution annealed and descaled conditions. When atmosphere control is used, descaling is not necessary.

    1.3 This specification covers tube 1/8 to 6 in. (3.2 to 152.4 mm) in outside diameter and 0.015 to 0.148 in. (0.41 to 3.7 mm) inclusive in wall thickness.

    1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys

    B899 Terminology Relating to Non-ferrous Metals and Alloys

    E8/E8M Test Methods for Tension Testing of Metallic Materials

    E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)


    ICS Code

    ICS Number Code 23.040.15 (Non-ferrous metal pipes)

    UNSPSC Code

    UNSPSC Code 11101711(Non ferrous alloy)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B1007-17

    Citation Format

    ASTM B1007-17, Standard Specification for Welded Precipitation Hardenable or Cold Worked, Nickel Alloy Tube, ASTM International, West Conshohocken, PA, 2017, www.astm.org

    Back to Top