ASTM B1000 - 15

    Standard Practices for Casting Preparation and Test Procedure of Porcelain Enamel-lined Pipe, Fittings, and Valves for Use in the Municipal Wastewater, Sewage, and Water Treatment Industry

    Active Standard ASTM B1000 | Developed by Subcommittee: B08.12

    Book of Standards Volume: 02.05


      Format Pages Price  
    PDF 3 $42.00   ADD TO CART
    Hardcopy (shipping and handling) 3 $42.00   ADD TO CART



    1. Scope

    1.1 The following procedures and practices are intended to provide guidelines for processing and quality control that will provide acceptable results for the intended end use, keeping in mind the varying quality of the castings available.

    1.2 The recommendations are based on what have been acceptable industry standards and experiences for over 40 years of proven product usage.

    1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    NACE and SSPC Standard

    SP0188–2006

    NAPF Standard

    NAPF 500 Surface Preparation Standard for Ductile Iron Pipe and Fittings in Exposed Locations Receiving Special External Coatings and/or Special Internal Linings

    AWWA Standard

    AWWA C151 Ductile-Iron Pipe, Centrifugally Cast

    ASTM Standards

    D5162 Practice for Discontinuity (Holiday) Testing of Nonconductive Protective Coating on Metallic Substrates

    D5965 Test Methods for Specific Gravity of Coating Powders

    D7091 Practice for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to Ferrous Metals and Nonmagnetic, Nonconductive Coatings Applied to Non-Ferrous Metals


    ICS Code

    ICS Number Code 25.220.50 (Enamels)

    UNSPSC Code

    UNSPSC Code 40170000(Pipe piping and pipe fittings); 40141600(Valves)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B1000-15

    Citation Format

    ASTM B1000-15, Standard Practices for Casting Preparation and Test Procedure of Porcelain Enamel-lined Pipe, Fittings, and Valves for Use in the Municipal Wastewater, Sewage, and Water Treatment Industry, ASTM International, West Conshohocken, PA, 2015, www.astm.org

    Back to Top