ASTM A862 / A862M - 98(2020)

    Standard Practice for Application of Asphalt Coatings to Corrugated Steel Sewer and Drainage Pipe

    Active Standard ASTM A862 / A862M | Developed by Subcommittee: A05.17

    Book of Standards Volume: 01.06


      Format Pages Price  
    PDF 2 $46.00   ADD TO CART
    Hardcopy (shipping and handling) 2 $46.00   ADD TO CART



    Significance and Use

    3.1 Asphalt coating is used to provide additional protection for corrugated steel products (product) in corrosive or abrasive environments, or both.

    1. Scope

    1.1 This practice covers the post coating of corrugated steel pipe and corrugated structural steel plate with asphalt materials. This practice is intended for shop-applied coating only.

    1.2 The values stated in either inch-pound units or SI units shall be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, use each system independently of the other, without combining values in any way. The SI units are shown in brackets in the text for clarity, but they are the applicable values when the application is to be performed using SI units.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A849 Specification for Post-Applied Coatings, Pavings, and Linings for Corrugated Steel Sewer and Drainage Pipe


    ICS Code

    ICS Number Code 23.040.50 (Pipes and fittings of other materials)

    UNSPSC Code

    UNSPSC Code 40171500(Commercial pipe and piping)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0862_A0862M-98R20

    Citation Format

    ASTM A862 / A862M-98(2020), Standard Practice for Application of Asphalt Coatings to Corrugated Steel Sewer and Drainage Pipe, ASTM International, West Conshohocken, PA, 2020, www.astm.org

    Back to Top