| Format | Pages | Price |   |
![]() |
3 | $46.00 | ![]() |
|
![]() |
Hardcopy (shipping and handling) | 3 | $46.00 | ![]() |
![]() |
Standard + Redline PDF Bundle ![]() |
6 | $54.00 | ![]() |
Historical Version(s) - view previous versions of standard
More A01.03 Standards Related Products Standard References
Abstract
This specification covers carbon steel wire coils for general use. Steel samples shall be hard drawn, annealed in process, or annealed at finish size. The steel shall either be ingot cast or strand cast. The carbon steel shall also undergo tensile tests and shall conform to the required values of tensile strength. Final products shall be marked either by a tag or bar code.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers carbon steel wire, supplied in coils, for general use. It may be produced hard drawn, annealed in process, or annealed at finish size.
1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Federal Standard
Fed. Std. No. 123 Marking for Shipments (Civil Agencies) Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, https://quicksearch.dla.mil.ASTM Standards
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A510/A510M Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel, and Alloy Steel
A700 Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
Military Standards
MIL-STD-129 Marking for Shipment and StorageICS Code
ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)
UNSPSC Code
UNSPSC Code 31152200(Non electric iron and steel wire)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/A0853-19
Citation Format
ASTM A853-19, Standard Specification for Steel Wire, Carbon, for General Use, ASTM International, West Conshohocken, PA, 2019, www.astm.org
Back to Top