You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM A782/A782M-06

    Standard Specification for Pressure-Vessel Plates, Quenched-and-Tempered, Manganese-Chromium-Molybdenum-Silicon Zirconium Alloy Steel (Withdrawn 2010)

    Withdrawn Standard: ASTM A782/A782M-06 | Developed by Subcommittee: A01.11


      Format Pages Price  
    PDF 3 $50.00   ADD TO CART


    Withdrawn Rationale:

    This specification covers high-strength quenched and tempered alloy steel plates intended for use in fusion welded pressure vessels.

    Formerly under the jurisdiction of Committee A01 on Steel, Stainless Steel and Related Alloys, this specification was withdrawn in October 2010. This standard was withdrawn without replacement due to its limited use by the industry.

    1. Scope

    1.1 This specification covers high-strength quenched and tempered alloy steel plates intended for use in fusion welded pressure vessels.

    1.2 Plates furnished under this specification are available in three classes having different strength levels as follows:

    1.3 The thickness of plates under this specification is limited to a maximum of 2 in. [50 mm].

    1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system is to be used independently of the other without combining values from the two systems.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A20/A20M Specification for General Requirements for Steel Plates for Pressure Vessels

    A435/A435M Specification for Straight-Beam Ultrasonic Examination of Steel Plates

    A577/A577M Specification for Ultrasonic Angle-Beam Examination of Steel Plates

    A578/A578M Specification for Straight-Beam Ultrasonic Examination of Rolled Steel Plates for Special Applications


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0782_A0782M-06

    Citation Format

    ASTM A782 / A782M-06, Standard Specification for Pressure-Vessel Plates, Quenched-and-Tempered, Manganese-Chromium-Molybdenum-Silicon Zirconium Alloy Steel (Withdrawn 2010), ASTM International, West Conshohocken, PA, 2006, www.astm.org

    Back to Top