| Format | Pages | Price |   |
![]() |
2 | $54.00 | ![]() |
1. Scope
1.1 This specification covers hot-rolled carbon steel sheet and strip of commercial quality, in coils and cut lengths, having a maximum carbon of 0.15%. This material is intended for parts where bending, moderate forming or drawing, and welding may be involved.
1.2 This specification is not applicable to the steel covered by Specification A635/A635M.
1.3 The values stated in either acceptable metric units (SI) or in inch-pound units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/A0569_A0569M-98
Citation Format
ASTM A569 / A569M-98, Standard Specification for Steel, Carbon (0.15 Maximum, Percent), Hot-Rolled Sheet and Strip Commercial (Withdrawn 2000), ASTM International, West Conshohocken, PA, 1998, www.astm.org
Back to Top