ASTM A510M-08
Standard Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel [Metric] (Withdrawn 2011)
Withdrawn Standard: 
ASTM A510M-08 | Developed by Subcommittee: A01.03
| Format | Pages | Price | ||
 |
7 | $54.00 |  ADD TO CART |
Withdrawn Rationale:
This specification covers general requirements for carbon steel wire rods and uncoated coarse round wire in coils or straightened and cut lengths. Formerly under the jurisdiction of Committee A01 on Steel, Stainless Steel, and Related Alloys, this specification was withdrawn in December 2011 and replaced by Specification A510/A510M for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel, and Alloy Steel
1. Scope
1.1 This specification covers general requirements for carbon steel wire rods and uncoated coarse round wire in coils or straightened and cut lengths.
1.2 In case of conflict, the requirements in the purchase order, on the drawing, in the individual specification, and in this general specification shall prevail in the sequence named.
Note 1—This metric specification is equivalent to Specification A 510, and is compatible in technical content.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E30 Test Methods for Chemical Analysis of Steel, Cast Iron, Open-Hearth Iron, and Wrought Iron
E112 Test Methods for Determining Average Grain Size
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
Society of Automotive Engineers Standard
J1086 Numbering Metals and AlloysAIAG Standard
AIAG B-5 02.00 Primary Metals Identification Tag Application StandardReferencing This Standard
| Link Here | |||
| Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/A0510M-08
Citation Format
ASTM A510M-08, Standard Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel [Metric] (Withdrawn 2011), ASTM International, West Conshohocken, PA, 2008, www.astm.org
Back to Top