You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    ASTM A366/A366M-97e1

    Standard Specification for Commercial Steel (CS) Sheet, Carbon (0.15 Maximum Percent) Cold-Rolled (Withdrawn 2000)

    Withdrawn Standard: ASTM A366/A366M-97e1 | Developed by Subcommittee: A01.19


      Format Pages Price  
    PDF 2 $54.00   ADD TO CART


    1. Scope

    1.1 This specification covers cold-rolled carbon commercial sheet (CS), in coils or cut lengths. This material is intended for exposed or unexposed parts where bending, moderate drawing, forming, and welding may be involved.

    1.2 This specification is not applicable to Specification A109. Narrow widths multiple slit from wide sheet are not strip, unless they qualify as strip because of thickness, special finish, special edge, or special temper.

    1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.



    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0366_A0366M-97E01

    Citation Format

    ASTM A366 / A366M-97e1, Standard Specification for Commercial Steel (CS) Sheet, Carbon (0.15 Maximum Percent) Cold-Rolled (Withdrawn 2000), ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top