If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    ASTM A1108 - 17

    Standard Test Method for Determining the Ultimate Strength of Deep Corrugated Structural Plate Bolted Longitudinal Lapped Seams

    Active Standard ASTM A1108 | Developed by Subcommittee: A05.17

    Book of Standards Volume: 01.06

      Format Pages Price  
    PDF 6 $54.00   ADD TO CART
    Hardcopy (shipping and handling) 6 $54.00   ADD TO CART

    Significance and Use

    5.1 This test method provides a procedure for testing to determine the ultimate strength in compression of bolted longitudinal seams with lapped connections in deep corrugated structural plate. This test method is applicable to variable length longitudinal seams with circumferential seams between adjacent plates.

    Note 1: The testing is intended for bolted longitudinal seams in plate with the following corrugation sizes in Practice A796/A796M: 15 in. by 5.5. in. (Practice A796/A796M Tables 34 and 35), 20 in. by 9.5 in. (Practice A796/A796M Tables 36 and 37), and 16 in. by 6 in. (Practice A796/A796M Table 38 and 39).

    5.2 The maximum load achieved in this testing, along with normalization procedures in this test method, are used to establish values for ultimate strength of bolted structural plate longitudinal seams for design in accordance with Practice A796/A796M.

    1. Scope

    1.1 This test method provides a comprehensive method for determining the seam strength for bolted longitudinal lapped seams in deep corrugated structural steel plate. The test method includes a laboratory test procedure which specifies specimen preparation, test equipment, and data collection. The test method also includes a method to calculate seam strength from the test results. This standard test method is applicable to corrugated steel structures with ultimate strength of bolted seams provided in Practice A796/A796M.

    1.2 Units—The values stated in inch-pound units are to be regarded as standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A761/A761M Specification for Corrugated Steel Structural Plate, Zinc-Coated, for Field-Bolted Pipe, Pipe-Arches, and Arches

    A796/A796M Practice for Structural Design of Corrugated Steel Pipe, Pipe-Arches, and Arches for Storm and Sanitary Sewers and Other Buried Applications

    A902 Terminology Relating to Metallic Coated Steel Products

    ICS Code

    ICS Number Code 77.140.50 (Flat steel products and semi-products)

    UNSPSC Code

    UNSPSC Code 30102204(Steel plate)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A1108-17

    Citation Format

    ASTM A1108-17, Standard Test Method for Determining the Ultimate Strength of Deep Corrugated Structural Plate Bolted Longitudinal Lapped Seams, ASTM International, West Conshohocken, PA, 2017, www.astm.org

    Back to Top