Active Standard ASTM D1505 | Developed by Subcommittee: D20.70
Book of Standards Volume: 08.01
Historical (view previous versions of standard)
Significance and Use
The density of a solid is a conveniently measurable property which is frequently useful as a means of following physical changes in a sample, as an indication of uniformity among samples, and a means of identification.
This test method is designed to yield results accurate to better than 0.05 %.
Note 3—Where accuracy of 0.05 % or better is desired, the gradient tube shall be constructed so that vertical distances of 1 mm shall represent density differences no greater than 0.0001 g/cm.3 The sensitivity of the column is then 0.0001 g/cm3·mm. Where less accuracy is needed, the gradient tube shall be constructed to any required sensitivity.
1.1 This test method covers the determination of the density of solid plastics.
1.2 This test method is based on observing the level to which a test specimen sinks in a liquid column exhibiting a density gradient, in comparison with standards of known density.
Note 1—This test method is equivalent to ISO 1183-2.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D883 Terminology Relating to Plastics
D2839 Practice for Use of a Melt Index Strand for Determining Density of Polyethylene
D4703 Practice for Compression Molding Thermoplastic Materials into Test Specimens, Plaques, or Sheets
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ISO StandardISO 1183-2 Methods for Determining the Density and Relative Density of Noncellular Plastics Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.
ICS Number Code 83.080.01 (Plastics in general)
UNSPSC Code 13102000(Thermoplastic plastics)