ASTM D1212 - 91(2020) Standard Test Methods for Measurement of Wet Film Thickness of Organic Coatings

Gathering PDFs...

    ASTM D1212 - 91(2020)

    Standard Test Methods for Measurement of Wet Film Thickness of Organic Coatings

    Active Standard ASTM D1212 | Developed by Subcommittee: D01.23

    Book of Standards Volume: 06.01


    Download Standard (PDF)
    4 pages
    View Text Version
    4 pages
    Download HTML
    4 pages
    Download
    Standard + Redline (PDF)
    8 pages

    Historical (view previous versions of standard)


    ASTM D1212

    Significance and Use

    4.1 Wet film thickness measurements aid in the prediction of dry film thickness. In instances where dry film thickness cannot be measured nondestructively, wet film thickness is frequently specified. Also, the ability to determine wet film thickness during application can provide the opportunity to correct the application procedures.

    1. Scope

    1.1 These test methods cover the determination of wet film thickness of organic coatings such as paint, varnish, and lacquer. Two methods are described as follows:

    1.1.1 In Test Method A, the Wet Film Thickness Gage (English or Metric graduation (see 5.1)) is used to measure wet film thicknesses up to 60 mils on the English scale series, and up to 700 μm on the metric scale series (Sections 5 – 8).

    1.1.2 In Test Method B, the Pfund Gage is used to measure wet film thicknesses up to 14.2 mils (360 μm) (Sections 9 – 13).

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

    1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.



    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D823 Practices for Producing Films of Uniform Thickness of Paint, Coatings and Related Products on Test Panels

    ICS Code

    ICS Number Code 25.220.60 (Organic coatings)

    UNSPSC Code

    UNSPSC Code


    DOI: 10.1520/D1212-91R20

    ASTM D1212

    Citing ASTM Standards
    Back to Top