You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass

    Introducing Heterogeneity into Brittle Fracture Modeling of a 22NiMoCr37 Ferritic Steel Ring Forging

    Published: 01 January 2009

      Format Pages Price  
    PDF (4.2M) 22 $25   ADD TO CART
    Complete Source PDF (236M) 814 $139   ADD TO CART

    Cite this document

    X Add email address send
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word


    Microstructural observations of the 22NiMoCr37 “EURO” reactor pressure vessel (RPV) steel ring forging reveal that there is a banded structure along the radial direction, composed of alternate layers rich in bainite and ferrite of wavelength ∼1.5 ±0.75 mm. Heterogeneity at this meso (millimetre)-scale as well as at the micro (micrometre)-scale is currently not considered by conventional fracture mechanics. This paper describes the development of two numerical approaches aimed at incorporating such heterogeneity into the Beremin local approach model of cleavage failure, a model that has been used extensively for predicting the brittle fracture of ferritic RPV steels. The approaches developed combine the crystal plasticity finite element method (CPFEM) with continuum finite element analysis (FEA). CPFEM is applied to predict stress distributions at the microscale and to obtain phase-specific yield and flow properties for continuum FEA that derives stresses at the mesoscale. The results confirm that deformation heterogeneity on the micro- and mesoscales influences the local development of stress. At the microscale, the stress distribution within a representative volume of material located within the crack-tip plastic zone is shown to follow a normal distribution with a ratio of mean stress to standard deviation tending towards 0.1. These results indicate local stress levels that are within approximately ±20 % of those derived using continuum FEA. At the mesoscale, a periodic variation of stress is predicted within the larger representative volume. This variation is less dramatic than that observed at the microscale, though it still gives a spatial variation in maximum principal stress of approximately ±7 % between bainite- and ferrite-rich microstructural regions. These results suggest a significant influence of deformation heterogeneity on local stress levels, particularly at the microscale. However, the conventional Beremin cleavage fracture model, modified to account for microscale stress distribution, predicts only a modest influence of deformation heterogeneity on cleavage fracture probability, increasing Pf by just 5 %. This highlights the need to account for both the spatial variation in cleavage initiation sites as well as the distribution in stress throughout the microstructure. The paper describes one approach for this development.


    RPV steel, brittle fracture, Beremin model, microstructural heterogeneity, crystal plasticity

    Author Information:

    Zhao, Xinglong
    University of Manchester, Manchester,

    Lidbury, David
    Serco Assurance, Warrington,

    Quinta da Fonseca, João
    University of Manchester, Manchester,

    Sherry, Andrew
    University of Manchester, Manchester,

    Committee/Subcommittee: E08.03

    DOI: 10.1520/STP48784S