You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.


    Experimental Estimation of J-R Curves from Load-CMOD Record for SE(B) Specimens

    Published: Jan 2009

      Format Pages Price  
    PDF (3.1M) 21 $25   ADD TO CART
    Complete Source PDF (236M) 814 $139   ADD TO CART


    Fracture resistance of ductile materials is often characterized by a J-R curve, and measured using the fracture toughness testing standard ASTM E1820 (Standard Test Method for Measurement of Fracture Toughness). The recommended elastic unloading compliance method or resistance curve test method requires simultaneous measurements of applied load (P), load-line displacement (LLD), and crack-mouth opening displacement (CMOD) from a single test for the single-edge notched bend [SE(B)] specimen. The P-CMOD record is used to determine crack extension, and the P-LLD record in conjunction with the crack extension is used to calculate the J-integral. However, it is well known that while highly accurate CMOD measurements can be made, the measurement of LLD is less accurate and more difficult because of transducer mounting difficulties, specimen load point indentions and load train deflections, or a combination thereof. Extensive finite element analyses showed that the LLD-based J equation may give inaccurate results for a shallow-cracked SE(B) specimen because its geometry factor η may depend on the strain hardening exponent. In contrast for the same geometry, the CMOD-based η factor is insensitive to the hardening exponent, and thus a CMOD-based J equation could be more accurate to be used in the determination of J-R curves. Based on the energy principle, this paper proposes a CMOD-based J equation for a growing crack using an incremental function similar to the present ASTM E1820-06 formulation that is applicable to the J calculations for a J-R curve testing. The proposed CMOD-based J formulation contains two geometry factors, i.e., CMOD-based η and γ, and can consider the crack growth correction. The solutions of four geometry factors are presented for the SE(B) specimens with a wide range of crack length. The proposed formulation is then applied to determine J-R curves for HY80 steel using the load-CMOD record for SE(B) specimens, and the results are compared with those using the traditional LLD-based formulation. The comparison shows close agreement between these two formulations. It is recommended that the proposed formulation be used in ASTM E1820 to determine more accurate J-R curves and reduce test costs as well.


    fracture toughness testing, J-R, curve, crack extension, load-line displacement (LLD), crack mouth opening displacement (CMOD), SE(B) specimen

    Author Information:

    Zhu, Xian-Kui
    Senior Research Scientist and Senior Research Leader, Battelle Memorial Institute, Columbus, Ohio

    Leis, Brian N.
    Senior Research Scientist and Senior Research Leader, Battelle Memorial Institute, Columbus, Ohio

    Joyce, James A.
    Professor, U.S. Naval Academy, Annapolis, Maryland

    Committee/Subcommittee: E08.03

    DOI: 10.1520/STP48761S