You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.


    Transverse Strength of Masonry Walls

    Published: 0

      Format Pages Price  
    PDF (1.6M) 30 $25   ADD TO CART
    Complete Source PDF (7.3M) 138 $55   ADD TO CART


    Transverse strength of brick masonry walls is usually not directly recognized by most building codes. Indirectly, the transverse or flexural resistance of masonry walls is controlled by the height-to-thickness limitations imposed by nearly all codes. However, allowable extreme fiber stresses that would permit rational analysis is indeed lacking. The American Standard Building Code Requirements for Masonry make no provision for tension in masonry; however, through rules such as wall thickness-height ratios and lateral support requirements, ample lateral resistance is indirectly obtained. The Uniform Building Code is the only major code in this country that recognizes an allowable tensile stress in masonry subject to flexural loads. Therefore, the interest in the following series of tests was occasioned by the meager code basis on which to rationally design unreinforced masonry to meet lateral force requirements.

    Author Information:

    Monk, CB
    Manager, Structural Clay Products Research Foundation, Chicago, Ill.

    Committee/Subcommittee: E06.21

    DOI: 10.1520/STP39266S