You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.


    State-of-the-Art: Laboratory Hydraulic Conductivity Tests for Saturated Soils

    Published: 0

      Format Pages Price  
    PDF (1.5M) 49 $25   ADD TO CART
    Complete Source PDF (14M) 615 $82   ADD TO CART


    Hydraulic conductivity of saturated soils is measured in the laboratory with either rigid- or flexible-wall permeameters. Rigid-wall cells are preferred for granular materials, and either rigid- or flexible-wall cells are preferred for low-hydraulic conductivity materials, depending on the type of test specimen and the conditions being simulated. Procedures for selection and preparation of test specimens are critically important, even for laboratory-compacted materials. Either constant- or variable-head tests can be performed; either type of test will yield satisfactory results if used properly. For compressible materials, the head cannot change much or the test specimen will change volume. Permeation with deaired water until inflow and outflow rates equilibrate, supplemented with backpressure where appropriate, are needed to saturate test specimens. Permeation should continue until chemical equilibrium is established when testing with liquids other than water, e.g., chemical wastes.


    hydraulic conductivity, permeability, soil, permeameter, rigid-wall permeameter, flexible-wall permeameter, waste, leachate

    Author Information:

    Daniel, DE
    Professor of Civil Engineering, University of Texas, Austin, TX

    Committee/Subcommittee: D18.04

    DOI: 10.1520/STP23884S