You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.


    Evaluation of a New Mechanical Pressure Tester for Barrier Fabrics

    Published: 0

      Format Pages Price  
    PDF (144K) 10 $25   ADD TO CART
    Complete Source PDF (5.9M) 359 $76   ADD TO CART

    Cite this document

    X Add email address send
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word


    ASTM F23.40.04, Draft Test Method for the Resistance of Materials Used in Protective Clothing to Penetration by Synthetic Blood Using a Mechanical Pressure Technique, was evaluated and compared to three other barrier test methods that apply hydrostatic pressure to the liquid and fabric. The new instrument applies continuous mechanical pressure to the fabric and synthetic blood until penetration is visible, and the penetration pressure level is recorded. The barrier properties of 14 different surgical gown materials and control fabrics were measured using the new method and ASTM F 1670 and F 1671 and AATCC 127. Surgical gown materials reinforced with films, coatings, or membranes passed ASTM F 1670 and F 1671 and reached the highest pressure level attainable on the AATCC 127 and ASTM F23.40.04 tests. Single-layer and fabric reinforced gowns exhibited varying degrees of liquid resistance. The new method simulates the high mechanical pressures of short duration that occur during surgery. It deserves consideration as a standard.


    barriers, hydrostatic pressure, mechanical pressure, synthetic blood, medical textiles, surgical gowns, viral resistance, liquid resistance

    Author Information:

    McCullough, EA
    Professor of Textiles and Co-Director, Institute for Environmental Research, Kansas State University, Manhattan, KS

    Johnson, PW
    Director, Environmental Services, Mayo Clinic, Rochester, MN

    Committee/Subcommittee: F23.96

    DOI: 10.1520/STP19891S