You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass

    Oxidation Mechanism in Zircaloy-2—The Effect of SPP Size Distribution

    Published: 19 September 2014

      Format Pages Price  
    PDF (2.4M) 32 $25   ADD TO CART
    Complete Source PDF (120M) 1177 $265   ADD TO CART

    Cite this document

    X Add email address send
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word


    The metal/oxide interface region in Zircaloy-2 oxidized in autoclave was studied with transmission electron microscopy (TEM) and atom probe tomography. In addition to waviness on the micrometer scale the metal/oxide interface was found to have irregularities on a finer scale, and metal islands were found especially at metal hills (delayed parts of the oxidation front). The thickness of the sub-oxide layer varies considerably along the interface in the same sample, from 100 to virtually 0 nm. The sub-oxide composition may vary on a very fine scale (down to 5 nm), and it can sometimes be a mixture of sub-oxides with different oxygen content. The metal matrix in contact with the sub-oxide is saturated with up to 32 at. % oxygen, and the oxygen diffusion profile in the metal is in approximate agreement with literature data for pure Zr. However, the diffusion length appears to be somewhat larger at interface metal hills than under valleys, probably for both geometrical and stress state reasons. Hydride precipitates, hardly visible in conventional TEM, give a good image contrast when employing high angle annular dark field imaging. A model for the oxidation process is presented, where the creep deformation of the metal close to the interface and the formation of lateral cracks in the oxide are of highest importance. The effect of second phase particle (SPP) size is suggested to be twofold: Small and numerous SPPs give a stronger metal and therefore higher stress in the oxide. Small SPPs also nucleate many more lateral cracks in the oxide, which gives a weaker oxide. Together this leads to formation of large cracks associated with transition in the oxidation rate at an earlier time than for a material with larger and fewer SPPs, and thereby a higher oxidation rate.


    Zircaloy-2, oxidation, SPP, TEM, APT

    Author Information:

    Tejland, Pia
    Studsvik Nuclear AB, Nyköping,

    Andrén, Hans-Olof
    Chalmers Univ. of Technology, Dept. of Applied Physics, Göteborg,

    Sundell, Gustav
    Chalmers Univ. of Technology, Dept. of Applied Physics, Göteborg,

    Thuvander, Mattias
    Chalmers Univ. of Technology, Dept. of Applied Physics, Göteborg,

    Josefsson, Bertil
    Vattenfall Nuclear Fuel AB, Stockholm,

    Hallstadius, Lars
    Westinghouse Electric Sweden, Västerås,

    Ivermark, Maria
    Westinghouse Electric Sweden, Västerås,

    Dahlbäck, Mats
    Westinghouse Electric Sweden, Västerås,

    Committee/Subcommittee: B10.02

    DOI: 10.1520/STP154320130052