You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass

    Effect of Alloying Elements on Hydrogen Pickup in Zirconium Alloys

    Published: 17 June 2014

      Format Pages Price  
    PDF (1.6M) 36 $25   ADD TO CART
    Complete Source PDF (120M) 1177 $265   ADD TO CART

    Cite this document

    X Add email address send
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word


    Although the optimization of zirconium-based alloys has led to significant improvements in hydrogen pickup and corrosion resistance, the mechanisms by which such alloy improvements occur are still not well understood. In an effort to understand such mechanisms, we conducted a systematic study of the alloy effect on hydrogen pickup, using advanced characterization techniques to rationalize precise measurements of hydrogen pickup. The hydrogen pickup fraction was accurately measured for a specially designed set of commercial and model alloys to investigate the effects of alloying elements, microstructure, and corrosion kinetics on hydrogen uptake. Two different techniques for measuring hydrogen concentrations were used: a destructive technique, vacuum hot extraction, and a non-destructive one, cold neutron prompt gamma activation analysis. The results indicate that hydrogen pickup varies not only from alloy to alloy, but also during the corrosion process for a given alloy. These variations result from the process of charge balance during the corrosion reaction, such that the pickup of hydrogen decreases when the rate of electron transport or oxide electronic conductivity (σe−ox) through the protective oxide increases. According to this hypothesis, alloying elements (either in solid solution or in precipitates) would affect the hydrogen pickup fraction by modifying σe−ox. Because the mechanism whereby these alloying elements are incorporated into the oxide layer is critical to changing electron conductivity, the evolution of the oxidation state of two common alloying elements, Fe and Nb, when incorporated into the growing oxide layers of two commercial zirconium alloys (Zircaloy-4 and ZIRLO) and model alloys (Zr-0.4Fe-0.2Cr and Zr-2.5Nb) was investigated using x-ray absorption near-edge spectroscopy with microbeam synchrotron radiation on cross-sectional oxide samples. The results show that the oxidation of both Fe and Nb is delayed in the oxide layer relative to that of Zr, and that this oxidation delay is related to the variations of the instantaneous hydrogen pickup fraction with exposure time.


    Hydrogen pick-up, Zirconium alloys, CNPGAA, XANES, alloying elements, electronic conductivity

    Author Information:

    Couet, Adrien
    Dept. of Mechanical and Nuclear Engineering, Penn State Univ., University Park, PA

    Motta, Arthur T.
    Dept. of Mechanical and Nuclear Engineering, Penn State Univ., University Park, PA

    Comstock, Robert J.
    Westinghouse Electric Company LLC, Pittsburgh, PA

    Committee/Subcommittee: B10.02

    DOI: 10.1520/STP154320120215