SYMPOSIA PAPER Published: 01 April 2012
STP153220120013

Mechanical and Microstrutural Characterization of Weldments of Ferritic Stainless Steel AISI 444 Using Austenitic Stainless Steels Filler Metals

Source

The objective of this study was to investigate the influence of the filler metal on the microstructure and mechanical properties of ferritic stainless steel AISI 444 welded using two types of filler metal of austenitic stainless steel. Microstructure examinations showed that in both welded joints grain growth occurred in the heat affected zone (HAZ). The results also showed that the fusion zone of the weld joints using E309L filler metal presented a discontinuous network of delta ferrite unlike the fusion zone of the weld joint using E316L. Tensile tests showed that the failures of specimens always occurred in the HAZ and that the weldments using E316L filler metal presented tensile strength lower than that of the weldment using E309L filler metal. In the fusion zone of the weldments using E316L filler metal, values for hardness were found to be higher than those found in the fusion zone of the E309L filler metal.

Author Information

Antunes, Pedro, Duarte
Institute of Mechanical Engineering, Federal Univ. of Itajubá, UNIFEI, BR
Corrêa, Edmilson, Otoni
Institute of Mechanical Engineering, Federal Univ. of Itajubá, UNIFEI, BR
Barbedo, Nancy, Delducca
Institute of Mechanical Engineering, Federal Univ. of Itajubá, UNIFEI, BR
de Oliveira Souza, Paola
Institute of Mechanical Engineering, Federal Univ. of Itajubá, UNIFEI, BR
Gonçalves, José, Luiz
Institute of Mechanical Engineering, Federal Univ. of Itajubá, UNIFEI, BR
Diacenco, Adriana, Amaro
Institute of Mechanical Engineering, Federal Univ. of Itajubá, UNIFEI, BR
Price: $25.00
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Developed by Committee: D02
Pages: 176–189
DOI: 10.1520/STP153220120013
ISBN-EB: 978-0-8031-9417-5
ISBN-13: 978-0-8031-7518-1