You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.


    Neutron Flux Estimations Based on Niobium Impurities in Reactor Pressure Vessel Steel


      Format Pages Price  
    PDF (176K) 10 $25   ADD TO CART
    Complete Source PDF (15M) 846 $131   ADD TO CART

    Cite this document

    X Add email address send
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word


    The use of (ppm level) niobium impurities in reactor pressure vessel (RPV) steel for neutron flux estimations based on the reaction 93Nb (n,n′) 93mNb has been reported previously [1].

    The method has now been further investigated and refined.

    Small niobium fractions in RPV steel (≈ ppm) and plating (≈1 %) materials have been separated by ion exchange chromatography in one to three steps. The measured Nb fractions in samples from some four pressure vessel (RPV) base materials were 1 to 3 ppm. The purification of tens of milligrams of RPV material provides sufficient amounts of niobium for mass determination with a highly sensitive (10−5 ppm) Inductively Coupled Plasma Mass Spectrometer (ICP-MS).

    The 93mNb and small remaining 54Mn activities were measured with a calibrated Liquid Scintillation Counter (LSC) based on dual label technique and almost 100 per cent efficiency to 93mNb. One purification is needed for plating materials (≈1 % Nb) and two purifications of about one gram of steel with Nb impurities in order to resolve the needed activities (≈10 Bq 93mNb/ug Nb).

    Other neutron induced reactions in Mo produce interfering 93mNb, 92mNb and 95Nb. With about 0.5 per cent Mo in the RPV steel, several tens of ppm of Nb (Nb/Mo > 0.01) are typically needed in order to obtain a clearly dominant 93mNb activity from the 93Nb (n,n′) 93mNb reaction of interest. RPV plating materials with 0.5...1 % of alloyed Nb have insignificant degradation from Mo on the measured 93mNb activities.

    Thus, a sufficient chemical purification of Nb was achieved and the specific 93mNb activities could be measured for all types of available RPV and plating samples. However, other competing and 93mNb producing reactions such as 92Mo(n,γ)93Mo (3500 y), disintegrating to 93mNb, strongly degraded the results in samples with low Nb/Mo ratios. Samples with sufficiently high Nb/Mo ratios may be eventually selected for dosimetric purposes since the Nb and Mo mass fractions vary with position and type of material.

    The achieved accuracy of the measured specific 93mNb activities was about ±3 % (lσ) in irradiated RPV plating materials and about ±4 % for Nb ppm impurities.


    neutron dosimetry, neutron spectrum, neutron flux, ion-exchange, chromatography, niobium, niobium separation, niobium purification

    Author Information:

    Baers, LB
    Senior research scientist, Technical Research Centre of Finland (VTT), Reactor Laboratory, Espoo,

    Hasanen, EK
    Senior research scientist, Technical Research Centre of Finland (VTT), Reactor Laboratory, Espoo,

    Committee/Subcommittee: E10.08

    DOI: 10.1520/STP15113S