You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.


    Performance of Molded Expanded Polystyrene (EPS) Thermal Insulation in Below-Grade Applications

    Published: 0

      Format Pages Price  
    PDF (272K) 13 $25   ADD TO CART
    Complete Source PDF (7.6M) 405 $143   ADD TO CART

    Cite this document

    X Add email address send
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word


    Molded expanded polystyrene (EPS) products are used for a wide variety of construction applications, including such applications as thermal insulation for below-grade foundations, frost-protected shallow foundations and floor slabs. The performance of EPS thermal insulation has been demonstrated in these applications for more than 40 years.

    When used as below-grade insulation in building construction, EPS insulation is one component in a system whose purpose is to minimize heat loss and, in turn, energy consumption in that portion of the building envelope. As with any product, the successful use of EPS insulation depends upon its correct installation in accordance with good building practice.

    Material properties required for the selection of the correct EPS insulation product for below-grade applications and performance characteristics are discussed in this paper. In addition to identifying material properties considered important in below-grade applications, current laboratory test methods used for measuring the property, where applicable, and references demonstrating performance of EPS product after defined in service periods are cited. The role each material property plays in the performance of EPS insulation is also highlighted.


    below-grade, building insulation, EPS, product performance, molded expanded polystyrene insulation, thermal insulation

    Author Information:

    Whalen, J
    Technical Marketing Manager, Registered Professional Engineer, Plasti-Fab, Division of PFB Corporation, Calgary, Alberta

    Committee/Subcommittee: C16.22

    DOI: 10.1520/STP11025S