You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    Volume 47, Issue 4 (December 2018)

    A Precision Statement for Fatigue of Solid Round Wire

    (Received 8 May 2018; accepted 4 September 2018)

    Published Online: 18 December 2018

    CODEN: JTEVAB

      Format Pages Price  
    PDF (1021.28 KB) 16 $25   ADD TO CART

    Cite this document

    X Add email address send
    X
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word



    Abstract

    ASTM E2948, Standard Test Method for Conducting Rotating Bending Fatigue Tests of Solid Round Fine Wire, is a procedure for rotating bending fatigue tests of fine wire to obtain the fatigue strength for metallic materials at a specified life in the fatigue regime where the strains are predominately and nominally linear elastic. This method is limited to the fatigue testing of small diameter solid round wire subjected to constant amplitude, completely reversed, periodic strain. The methodology can be useful in assessing the effects of inclusions, melt technique, and cold work processing. Data obtained in accordance with ASTM E2948 is subject to variability because of many factors. An inter-laboratory study (ILS) was performed to assess variability of the data and to develop a precision statement for ASTM E2948. Ten laboratories participated in the ILS. The samples consisted of two materials, Nitinol and 35N LT. Each material was supplied from a single lot from a single manufacturer. Samples were tested at three different strain amplitudes with ten replicates at each strain level. Variability of the resulting data was quantified as reproducibility limits, between laboratory variability, and repeatability limits, within laboratory variability. A precision statement for ASTM E2948 was formulated based on the reproducibility and repeatability limits determined from the inter-laboratory study. The viability of the limits is assessed with Monte Carlo simulations. Alternative methods of analysis using nonparametric statistics and bootstrap methods are discussed.

    Author Information:

    Jerina, K. L.
    Department of Mechanical Engineering and Materials Science, Washington University, St Louis, MO

    Mitchell, M. R.
    Mechanics and Materials Consulting, Flagstaff, AZ


    Stock #: JTE20180319

    ISSN:0090-3973

    DOI: 10.1520/JTE20180319

    Author
    Title A Precision Statement for Fatigue of Solid Round Wire
    Symposium ,
    Committee E08