You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    Volume 48, Issue 4 (July 2020)

    Study on Dimension Measurement for Gas Guide Groove of Gun Barrel

    (Received 5 December 2016; accepted 30 May 2018)

    Published Online: 2020

    CODEN: JTEVAB

      Format Pages Price  
    PDF (1.63 MB) 15 $25   ADD TO CART

    Cite this document

    X Add email address send
    X
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word



    Abstract

    An automatic measurement system based on the stationary wavelet transform (SWT) of vibration signal is developed to obtain the depth and width of gas guide grooves in the gun barrel. The system consists of the programmable logic controller module used to control the motions of system components, a mechanical apparatus used to fix the gun barrel and position the transducer, and a measurement device used to capture and analyze the measured data. With the SWT, the interference noise, baseline wander, and interference harmonics are successively eliminated from the captured displacement signal. Afterwards, the peak and valley points are detected out, which, respectively, represent the information of groove depth and of groove width. Finally, the dimensions of the gas guide groove are determined according to the points detected out and the calibration information. In the experiment, the steps of data processing are provided in detail, and the analysis results show that the measuring error is less than 3 %, which can meet the actual requirements.

    Author Information:

    Liu, Xiaofeng
    The State Key Laboratory of Mechanical Transmission, Chongqing University, Chongqing

    Yang, Kangjun
    The State Key Laboratory of Mechanical Transmission, Chongqing University, Chongqing

    Bo, Lin
    The State Key Laboratory of Mechanical Transmission, Chongqing University, Chongqing


    Stock #: JTE20160622

    ISSN:0090-3973

    DOI: 10.1520/JTE20160622

    Author
    Title Study on Dimension Measurement for Gas Guide Groove of Gun Barrel
    Symposium ,
    Committee A01