You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    Volume 44, Issue 2 (March 2016)

    Special Issue Paper

    Comparison of Flow Curves of AA 5457-O Sheet Material Determined by Hydraulic Bulge and Tensile Tests at Warm Forming Temperatures

    (Received 15 August 2015; accepted 7 January 2016)

    Published Online: 02 March 2016

    CODEN: JTEVAB

      Format Pages Price  
    PDF (4.5M) 15 $25   ADD TO CART

    Cite this document

    X Add email address send
    X
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word



    Abstract

    The deformation behavior of sheet materials changes according to temperature. It is possible that the formability of a material for different temperatures is investigated and the flow curves are obtained by using a hydraulic bulge test. Generally, biaxial stress state occurs in real forming processes. Flow curves can be derived from the hydraulic bulge test for the biaxial stress state, and the higher strain values can be achieved in comparison to the tensile test without extrapolation. Hydraulic bulge tests are preferred instead of tensile tests on account of presuming the problems can occur during the formation process of sheet material, being informed about the formability of material at the current pressure and temperature states, and obtaining flow curves to perform more accurate process simulations. In this study, the flow curves for the material AA5754-O were obtained using the warm bulge test and by considering the strain rates. The sections of the curves that can be used in simulation were identified, and these curves were comparatively investigated with respect to the curves obtained from the tensile test. In addition, case studies were performed in order to conduct more realisitic simulations using the results of the flow curves obtained from the bulge and tensile tests.


    Author Information:

    Şükür, Emine Feyza
    Department of Mechanical Engineering, Faculty of Engineering, Selcuk Univ., Konya,

    Türköz, Mevlüt
    Department of Mechanical Engineering, Faculty of Engineering, Selcuk Univ., Konya,

    Dilmeç, Murat
    Department of Mechanical Engineering, Faculty of Engineering and Architecture, Necmettin Erbakan Univ., Konya,

    Halkacı, Hüseyin Selçuk
    Department of Mechanical Engineering, Faculty of Engineering, Selcuk Univ., Konya,

    Halkacı, Mehmet
    Technical Sciences Vocational School of Higher Education, Selcuk Univ., Konya,


    Stock #: JTE20150346

    ISSN:0090-3973

    DOI: 10.1520/JTE20150346

    Author
    Title Comparison of Flow Curves of AA 5457-O Sheet Material Determined by Hydraulic Bulge and Tensile Tests at Warm Forming Temperatures
    Symposium ,
    Committee E28