You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    Volume 45, Issue 3 (May 2017)

    Profile Analysis for a Gear With Conical Teeth

    (Received 8 June 2015; accepted 16 February 2016)

    Published Online: 24 May 2017

    CODEN: JTEVAB

      Format Pages Price  
    PDF (1.54 MB) 9 $25   ADD TO CART

    Cite this document

    X Add email address send
    X
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word



    Abstract

    This paper presents a gear pair mechanism, a pinion, and a gear with conical teeth. The gear, or generating surface, has conical teeth distributed on a cylindrical surface. The purpose here was to present a mathematical model and equation for meshing of the proposed gear with conical teeth. A simple method using gear theory was used to determine a generated surface that meshes with the generating surface. The mathematical model of the generated surface can be obtained by the envelope of the family of the generating surfaces. As an example, the proposed gear pair for a gear ratio of 4:3 was demonstrated through the aid of the proposed mathematical model. Based on the geometrical models presented, the author varied the conical angle of the proposed gear between 0 and 20° and examined their contact stresses and deformation. Results showed that the minimum von-Mises stress was at the conical angle of 15° and the minimum deformation was at the conical angle of 17°. If the given parameters are over the dimensional limit of the generating surface, the equation of meshing of generated surface cannot exist. The condition of the dimensional limit was determined in this paper. Results from these mathematical models should have applications in the design of gear mechanism.


    Author Information:

    Yang, Hsueh-Cheng
    Graduate Inst. of Vehicle Engineering, National Changhua Univ. of Education, Changhua City,

    Huang, Tsun-Hui
    Graduate Inst. of Vehicle EngineeringNational Changhua Univ. of Education, Changhua City,


    Stock #: JTE20150245

    ISSN:0090-3973

    DOI: 10.1520/JTE20150245

    Author
    Title Profile Analysis for a Gear With Conical Teeth
    Symposium ,
    Committee E28