You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    Volume 44, Issue 6 (November 2016)

    Back-Pressure Saturated Constant-Rate-of-Strain Consolidation Device With Bender Elements: Verification of System Compliance

    (Received 20 July 2014; accepted 14 July 2015)

    Published Online: 29 November 2016

    CODEN: JTEVAB

      Format Pages Price  
    PDF (2.4M) 12 $25   ADD TO CART

    Cite this document

    X Add email address send
    X
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word



    Abstract

    A back-pressure saturated, constant-rate-of-strain (BP-CRS) consolidation device was modified to incorporate bender elements (BE). A series of laboratory tests were conducted on a dummy brass sample and on kaolinite soil samples, using the BP-CRS and BP-CRS-BE devices, to determine the amount of system compliance for the BP-CRS-BE device, as compared to the BP-CRS device. The amount of machine deflection was determined for both the BP-CRS-BE device and BP-CRS device. Two approaches (quick and slow) were evaluated for determining the machine deflection. The machine deflection results, as obtained from both methods, were comparable; therefore, the use of the quick method is recommended. The respective average amount of maximum machine deflection (brass sample) and maximum corrected vertical deformation (kaolinite sample) for the BP-CRS and BP-CRS-BE devices were 0.78 mm and 0.88 mm (machine deflection) and 3.15 mm and 3.43 mm (soil deformation), respectively. Consolidation parameters were determined by subtracting the amount of respective machine deflection from the amount of vertical deformation that was measured during the tests that were performed on kaolinite soil samples. The consolidation parameters, as obtained from both devices, were also comparable. The average values of recompression index (Cr), compression index (Cc), swell index (Cs), and coefficient of consolidation (Cv) for the kaolinite samples that were tested in the BP-CRS and BP-CRS-BE devices were 0.07 and 0.08, 0.19 and 0.21, 0.08 and 0.07, and 9.3E-8 m2/s and 9.6E-7 m2/s, respectively. Because similar values were obtained for the consolidation parameters, as obtained by using wither the BP-CRS device or the BP-CRS-BE device, the use of the newly designed BP-CRS-BE device is advocated because the BP-CRS-BE device also enabled collection of shear wave velocity measurements while the sample was being subjected to various stress levels.


    Author Information:

    Zhao, Yi
    Dept. of Civil Engineering, Univ. of Arkansas, Fayetteville, AR

    Coffman, Richard A.
    Dept. of Civil Engineering, Univ. of Arkansas, Fayetteville, AR


    Stock #: JTE20140291

    ISSN:0090-3973

    DOI: 10.1520/JTE20140291

    Author
    Title Back-Pressure Saturated Constant-Rate-of-Strain Consolidation Device With Bender Elements: Verification of System Compliance
    Symposium ,
    Committee D18