You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    If you are an ASTM Compass Subscriber and this document is part of your subscription, you can access it for free at ASTM Compass
    Volume 7, Issue 1 (September 2018)

    An Experimental Study and Parameters Optimization on Duplex Turning of Titanium Alloy

    (Received 21 March 2018; accepted 3 August 2018)

    Published Online: 24 September 2018

    CODEN: MPCACD

      Format Pages Price  
    PDF (1.24 MB) 22 $25   ADD TO CART

    Cite this document

    X Add email address send
    X
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word



    Abstract

    The present article focuses on analyzing the cutting behavior of the duplex turning process for turn-cut machining of aerospace material, especially for titanium alloy. The experiments are conducted on a homemade setup that was mounted on a lathe machine. Each experiment was replicated twice to avoid variability, and a total of 31 experimental data are collected according to the Central Composite Rotating Design matrix. The feed rate, cutting velocity, and depth of cuts (primary and secondary) are taken as control parameters, while the average surface roughness, primary cutting force, and secondary cutting force are taken as response parameters. The experimental data are used to develop an empirical model using Response Surface Methodology (RSM). The developed RSM model has been experimentally tested and used to generate the response surfaces for parametric studies. Finally, the responses are optimized using D-optimality criteria, and the optimal results are experimentally validated. The result shows that RSM models are well fitted with experimental values with percentage errors of 5.03, 4.77, and 4.87 % for the Fp, Fs, and Ra, respectively. Furthermore, the optimal cutting condition shows significant improvement in the responses, i.e., 4.22, 3.72, and 2.85 % for the Fp, Fs, and Ra, respectively.

    Author Information:

    Yadav, Ravindra Nath
    Department of Mechanical Engineering, BBD National Institute of Technology and Management, Lucknow,


    Stock #: MPC20180053

    ISSN:2379-1365

    DOI: 10.1520/MPC20180053

    Author
    Title An Experimental Study and Parameters Optimization on Duplex Turning of Titanium Alloy
    Symposium ,
    Committee B10