You are being redirected because this document is part of your ASTM Compass® subscription.
    This document is part of your ASTM Compass® subscription.

    Volume 41, Issue 4 (July 2018)

    Small-Scale Pullout Test of a Geogrid-Reinforced Unsaturated Soil with Suction Monitoring

    (Received 18 August 2015; accepted 27 October 2017)

    Published Online: 2018

    CODEN: GTJODJ

      Format Pages Price  
    PDF (2.36 MB) 18 $25   ADD TO CART

    Cite this document

    X Add email address send
    X
      .RIS For RefWorks, EndNote, ProCite, Reference Manager, Zoteo, and many others.   .DOCX For Microsoft Word



    Abstract

    The use of local fine-grained soils in geosynthetic-reinforced structures can significantly reduce costs when granular materials are difficult to access. Another beneficial aspect of these soils is that enhanced mechanical behavior is expected with fine-grained soils under unsaturated conditions. With structures built in unsaturated conditions, stability analyses based on unsaturated soil mechanics would properly characterize and accurately predict the structural behavior with fine-grained soils. Accordingly, the interface shear strength between fine-grained soils and geosynthetics should also be assessed by unsaturated pullout or direct shear testing. In this article, the effect of matric suction on the pullout behavior of a polyester geogrid embedded in a fine-grained soil was evaluated using a small-scale testing apparatus. A miniature tensiometer located in the proximity of the soil-geogrid interface enabled monitoring of the matric suction of soil during pullout to evaluate its effect on the interface shear strength. A design approach for prediction of unsaturated interface strength is also assessed in this study. Three typical values of matric suction were identified during pullout: initial, peak, and residual. In the case of interfaces under water inundation, the pore water pressures developed and increased with the increase of overburden pressures. For drier interfaces, matric suction increases with increases of overburden pressure. Significant reductions (60 %) in peak pullout forces were observed for minor increases in soil moisture contents. Analyses using the moisture reduction factor indicated up to a 70 % loss of soil-geogrid interface shear strength as a result of wetting. The increase in unsaturated soil-geogrid interface strength due to the reduction of moisture content was attributed more to adhesion than to friction for the fine-grained soil used in this research. The analytical approach proposed in this study to predict the pullout strength of unsaturated interfaces has been demonstrated to be quite consistent with the actual strength values assessed from the small-scale pullout tests, primarily for higher values of overburden pressures. Matric suction values obtained from the soil-water retention curve were shown to be reliable parameters for use in the proposed analytical approach for prediction of the pullout strength of unsaturated soil-geosynthetic interfaces.

    Author Information:

    Portelinha, Fernando H. M.
    Federal University of São Carlos, Civil Engineering Department - DECiv, São Carlos, São Paulo

    Pereira, Vinicius R. G.
    Geosolucoes Geotechnical and Environmental Engineering, São Carlos, São Paulo

    Correia, Natalia S.
    Federal University of São Carlos, Civil Engineering Department - DECiv, São Carlos, São Paulo


    Stock #: GTJ20150182

    ISSN:0149-6115

    DOI: 10.1520/GTJ20150182

    Author
    Title Small-Scale Pullout Test of a Geogrid-Reinforced Unsaturated Soil with Suction Monitoring
    Symposium ,
    Committee D35