ASTM WK74977

    Revision of B1000 - 15 Standard Practices for Casting Preparation and Test Procedure of Porcelain Enamel-lined Pipe, Fittings, and Valves for Use in the Municipal Wastewater, Sewage, and Water Treatment Industry

    (What is a Work Item?)

    Active Standard: B1000 - 15

    Developed by Subcommittee: B08.12 | Committee B08 | Contact Staff Manager



    fittings; pipe; porcelain enamel;;


    Section 3.3 Change visibly to visually Section 4.2 Change Reference NAPF 500 for iron or SSPC for steel for surface condition requirements. To Reference NAPF 500-03-04 Abrasive Blast Cleaning of Ductile Iron Pipe for iron or SSPC-SP 5/NACE No. 1 White Metal Blast Cleaning for steel surface condition requirements. Section 7.1.4 Change The sponge should be moved over the surface at a moderate rate approximately 0.3 m/s (1 ft/s) using a two pass (in and out)motion over each area. To The sponge should be moved over the surface at a moderate rate approximately 0.3 m/s (1 ft/s) using a one pass motion over the dry area. To prevent telegraphing, care should be taken to ensure that the solution is wiped dry from any previously detected discontinuity before continuing testing. Section 8.2 Change The test documents should identify each individual items tested by an identifying mark number and description, the Quality Control Sequence Number, date tested, inspectors initials, number of holidays detected, and the thickness of the lining in mils. To The quality control document should identify the individual items tested with their description, sequence numbers, date lined, date tested, inspectors initials, wet sponge holiday test results, and average lining thickness. As a minimum the lined pipe or fitting should be identified with the application date, sequence number, and number of holidays detected.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:

    Technical Contact:
    Charles Baldwin


    B08 (21-01)

    Ballot Item Approved as B1000-2021 and Pending Publication