ASTM WK69730

    New Specification for Additive Manufacturing -- Wire for Directed Energy Deposition (DED) Processes in Additive Manufacturing

    (What is a Work Item?)

    Developed by Subcommittee: F42.05 | Committee F42 | Contact Staff Manager



    WK69730

    1. Scope

    1.1 This specification covers requirements for wire to be used in wire-directed energy deposition (DED) additive manufacturing (AM) for high-value manufacturing. It covers material including: composition, dimensions and tolerances, cast/helix, surface condition, internal condition, marking, packaging, materials handling, storage, and testing methods. 1.2 This specification is intended for use by wire suppliers, wire material developers and manufacturers, DED machinery developers and manufacturers, DED users, and DED component end users. 1.3 This specification does not cover use conditions, for example, processing parameters. 1.4 UnitsThe values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of international Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


    Keywords

    12.1 additive manufacturing; directed energy deposition; wire

    Rationale

    Directed energy deposition (DED) additive manufacturing (AM) can enable reductions in cost, lead time, and material waste compared to other manufacturing techniques. It achieves this through the ability to create parts, including near-net-shaped parts, by melting and depositing material in layers, with high deposition rates. Reductions in cost, lead time, and material waste have significant impact on high-value manufactured parts. Different heat sources can be used to melt the material including arc, electron beam, and laser. Both wire and powder can be used as material. One challenge facing industrialization of DED AM is a lack of related standards. To date, welding wire specifications are used for wire for DED AM, but these may not be suitable. It is the intention of this specification to outline requirements for composition, dimensions, and condition of wire for high-value DED AM in addition to marking, packaging, handling, and storage of the wire. Recommendations for testing methods are also listed. This specification defines different DED AM processes and specifies different product types that can be used for the processes. This specification aims to enhance the understanding of wire for DED AM and wire manufacturing and improve communication between customers and manufacturers or suppliers of materials. Ti6Al4V is the most extensively researched material for DED AM. Materials that can be deposited using DED AM include, but are not limited to, Ti6Al4V.

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    08-29-2019

    Technical Contact:
    Emma Ryan

    Item:
    002

    Ballot:
    F42 (19-06)

    Status:
    Negative Votes Need Resolution