ASTM WK69443

    Revision of D4417 - 14 Standard Test Methods for Field Measurement of Surface Profile of Blast Cleaned Steel

    (What is a Work Item?)

    Active Standard: D4417 - 19

    Developed by Subcommittee: D01.46 | Committee D01 | Contact Staff Manager



    WK69443


    Keywords

    abrasive; abrasive blast cleaning; anchor pattern; surface profile; surface roughness;

    Rationale

    D4417-14 has already been balloted extensively by D01.46 and the D01 Main committees in a series of 11 ballots since 2015, for the purposes of: 1.) adding terminology and calibration sections, 2.) expanding the report section, 3.) incorporating peak count/peak density measurement parameters from replica tape, 4.) merging D7127 as a Method D to the Procedure section. All content in this document have already been balloted without negative votes by both the D01 and D01.46 subcommittee (Ballot D01(17-02)). Unfortunately, that ballot died as a result of negatives that became the subject of a subsequent ballot and are now settled. Due to a misunderstanding, only those passages that received negative votes became the subject of the subsequent ballot (Ballot D01(18-02)- subsequently approved and indicated in purple with the note: Wording already approved in D01(18-02) Ballot, thus wording is not included in this ballot). The revision wording below is identical to the wording of the D01(17-02) ballot, which is why this ballot being issued concurrently. Approval of the revised portions below is required for the publication of the updated D4417.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    08-07-2019

    Technical Contact:
    Michael Beamish

    Item:
    021

    Ballot:
    D01 (19-08)

    Status:
    Ballot Item Approved as D4417-2019 and Pending Publication