ASTM WK66224

    New Test Method for Dry Filterability of Lubricants and Hydraulic Fluids by Mass Flow Technique

    (What is a Work Item?)

    Developed by Subcommittee: D02.N0 | Committee D02 | Contact Staff Manager



    WK66224

    1. Scope

    1.1 This test method covers determination of the dry filterability of lubricants and hydraulic fluids based upon mass flow rate measurements through a 0.8 m membrane after ageing. The procedure applies to lubricants and hydraulic fluids that are formulated with American Petroleum Institute (API) Group I, II, III, IV, and certain V base stocks. Products formulated with water or base stocks that are heavier than water are out of scope. 1.2 Units--The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    Keywords

    filtration; filterability; filter blocking potential; water tolerance; laboratory filtration

    Rationale

    This standard improves upon current ISO methods that rely on volume flow rate measurements to assess lubricant filterability properties. THe use of mass flow rate facilitates automation of the data collection process.

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    12-12-2018

    Technical Contact:
    Joshua Jurs

    Status:
    Draft Under Development