ASTM WK54402

    New Test Method for Evaluating Ground Response Robot Mobility: Traverse Pitch/Roll Rail Obstacles

    (What is a Work Item?)

    Developed by Subcommittee: E54.09 | Committee E54 | Contact Staff Manager



    WK54402

    1. Scope

    The purpose of this test method, as a part of a suite of mobility test methods, is to quantitatively evaluate a remotely teleoperated robots capability of traversing in complex terrain in confined areas. The apparatus associated with this test method challenges specific robot capabilities in repeatable ways to facilitate direct comparison of different robot models as well as particular configurations of similar robot models. The apparatus specifies a test course rails in specified directions. This apparatus can fit into a standard ISO shipping container to facilitate testing in temperature extremes and other environmental conditions such as darkness, smoke, rain, etc. The primary metric is whether the robot is able to fully traverse the specified route for a specified, statistically significant number of repetitions. A secondary metric, the time the robot takes to complete the traverse task, provides a relative indication of performance. The suite of mobility test methods quantifies elemental capabilities necessary for ground robot emergency response applications. As such, the suite should be used collectively to capture overall mobility performance. The current, first set of the test methods include sustained speed on a flat surface, gap crossing, traverses on inclined planes, stairs, pipe steps, continuous ramp terrains, crossing ramp terrains, and symmetric step-field terrains, and towing tasks. Additional test methods will be developed within the suite to fully address robot mobility capabilities requirements. This suite of test methods characterizes the mobility capabilities of ground robots intended to be operated in human-scale, complex environments with variables including terrains, lighting, temperature, etc. Robots under test shall be teleoperated via operator control units (OCUs) that are out of sight and sound of the test apparatuses but within the radio or tethered communications range, except when the communication is the subject of the testing. The robotic configuration as tested is to be specified clearly for all the subsystems and is to remain the same for all the suites of the test methods, as appropriate. Any variation in robot configuration must be retested for all the suites of the test methods to provide a comprehensive perspective of the performance for the particular robotic variant. Systems with assistive capabilities or autonomous behaviors are not specifically rewarded in the performance metric. However, any demonstration of improved remote operator/robot performance, efficiency, and/or survivability under test will be captured. Although these test methods were developed specifically for response robots, they may be applicable to other application domains. They can be used to ascertain operator proficiencies during training. They can provide practice tasks that exercise robotic control, including actuators, sensors, and operator interfaces. They can also serve as the performance objectives for the corresponding subsystems on the robots. There are currently no such standard test methods.

    These test methods were developed specifically for emergency response robots, they may be applicable to other application domains. They can be used to ascertain operator proficiencies during training. They can provide practice tasks that exercise robotic control, including actuators, sensors, and operator interfaces. They can also provide performance objectives for the corresponding subsystems on the robots.


    Keywords

    There are currently no such standard test methods.

    The title and scope are in draft form and are under development within this ASTM Committee.

    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:
    05-03-2016

    Technical Contact:
    Hui-Min Huang

    Status:
    Draft Under Development