The purpose of this proposed standard test method, as a part of a suite of robotic manipulation test methods, is to quantitatively evaluate a remotely teleoperated robots capability of conducting a Cut Strap task on specified targets. This proposed standard, including its procedure and apparatuses, is specified in a way that can differentiate the proposed capability, efficiency, and/or survivability under test. As such, this proposed standard challenges the robot capability in repeatable ways to facilitate direct comparisons among different robot models as well as particular configurations of similar robot models. The suite of manipulation test methods quantifies a corresponding set of elemental capabilities necessary for ground robot response applications. Therefore, the suite should be used collectively to capture the overall manipulation capabilities. For this proposed standard, the strap to be cut can be located at multiple locations on the cylinder base. The proposed standardization includes the apparatuses, task procedure, and metric. Additional test methods will be developed within the suite to fully address robot manipulation capabilities. Systems with assistive capabilities or autonomous behaviors are not specifically rewarded in the performance metrics. What will be captured is the tested capability.
KeywordsC-IED, counter-IED, Emergency, cut strap, human system interaction, improvised explosive device, IED, manipulation, operator control unit, OCU, remote teleoperation, responder, response, robot, robot task, test suite, urban search and rescue, US&R
This standard test method is to be developed to address the needs from response operations. However, it may be applicable to additional application domains. It can be used for the associated training purposes. This standard test method can provide practice tasks that exercise respective robotic control. This standard test method can also provide capability objectives for the involved subsystems on the robots.
The title and scope are in draft form and are under development within this ASTM Committee.Back to Top
Draft Under Development