ASTM WK43936

    Revision of D2122 - 98(2010) Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings

    (What is a Work Item?)

    Active Standard: D2122 - 16

    Developed by Subcommittee: F17.40 | Committee F17 | Contact Staff Manager


    1. Rationale

    These revisions to D2122 bring the conditioning and testing humidity requirements in alignment with those of D618 Standard Practice for Conditioning Plastics for Testing. Section 7.2.1 of D618 states, When tolerance for temperature is +/- 2C, the tolerance for relative humidity shall be +/- 10 %. The proposed revisions are to D2122, Sections 6.2 Conditioning and 6.3 Test Conditions. The tolerance on humidity increases from +/- 5% to +/- 10%. The revised wording is below. 6.2 Conditioning - Condition the test specimens at 73.4 +/- 3.6F (23 +/- 2C) and 50 +/- 10 % relative humidity for not less than 40 h prior to test in accordance with Procedure A of Practice D618, for those tests where conditioning is required or unless otherwise specified by the relevant ASTM material specification. 6.3 Test Conditions - Conduct tests in the Standard Laboratory Atmosphere of 73.4 +/- 3.6F (23 +/- 2C) and 50 +/- 10 % relative humidity, unless otherwise specified in the test methods, in this test method or specified by the relevant ASTM material specification.


    dimensions; measurement; plastic fittings; plastic pipe; thermoplastic fittings; thermoplastic pipe; Diameter--plastic pipe/fittings; Dimensions--plastic materials/applications; Length; Pipe fittings; Thermoplastic pipe/tube/fittings; Wall thickness;
    Citing ASTM Standards
    Back to Top
    Work Item Status

    Date Initiated:

    Technical Contact:
    Michael Conrad


    F17 (16-04)

    Ballot Item Approved as D2122-2016 and Pending Publication